Skip to main content

Doepfer A-143-4 Quad VCLFO/VCO


Four voltage-controlled LFOs/VCOs with triangle and square-wave outputs in a single module.

Each unit has one controller and two CV inputs for frequency adjustment. The output waveforms are triangle and square. In addition, there is a reset/direction input for units 1-3; the fourth unit has two separate inputs. Direction specifies the direction in which the wave moves after the reset, either falling or rising. If no cable is plugged into the fourth direction socket, it reacts to the normalized reset.

The frequency range can be switched between low and high frequencies, so that frequencies up to 15kHz can also be reached. Thus, each unit can also be used as a VCO, even if the CV characteristic does not match exactly 1V/octave. The LFOs/VCOs are temperature compensated and run stable after a warm-up time of approx. 10 minutes, independent of the outside temperature.

There is also a common section for all four LFOs simultaneously: it has CV inputs and controls for simultaneous frequency control and square/triangle outputs with mixing of all LFOs. Two-colour LEDs indicate the respective phase of the triangle (orange = positive / red = negative).

A large number of rear jumpers set additional frequency ranges, activate/deactivate frequency control via the internal CV bus for each LFO and set the control range of the frequency potentiometers (1 or 5 octaves).


325€

Power consumption: 100mA at +12V and 100mA at -12V

Depth: 60mm


22 HP


Choose your Language


Alex4

Alex4 Distribution GmbH
Lessingstr. 98, 100 – Haus 11
13158 Berlin
Germany

This email address is being protected from spambots. You need JavaScript enabled to view it.
www.alex4.de

Tel +49(0)30 - 61 65 100 40
Fax +49(0)30 - 61 65 100 49


Cookie Consent

By continuing to browse or by clicking 'Accept', you agree to the storing of cookies on your device to enhance your site experience and for analytical purposes.